GGS Optical Glass LCD Screen Protector 3" for Digital Cameras Review

Average Reviews:

(More customer reviews)I just purchased a brand new Panasonic Lumix FZ100 digital camera.
I figured I would buy a 3" screen protector to keep the color LCD screen free from fingermarks and dirt.
So I received the protector, peeled off the top protective paper and did the same thing on the bottom. It was positioned over the LCD display and it fit perfectly, or so I thought!
The protector was placed over the display, and I then went to close the LCD display, with no luck. You see, this unit was too thick to allow the display door to close. The best way of describing this piece is clear plastic with a frame around it. The problem is the frame is just high enough to prevent the door from closing! The plastic looked very clear and defect free, but if you can't use it on your camera it is no good to you at all.
My advice is that if you have a digital still camera with an LCD door that swings open, you can't use it!
A camera back with just a screen on the back is fine, but a closing LCD door makes this piece unusable!

Click Here to see more reviews about: GGS Optical Glass LCD Screen Protector 3" for Digital Cameras

GGS LCD screen protector is using ultra thin optical glass andspecial processing, it is high transparency, anti-scrape, anti-bump,anti-aging and easy to install. Features:liIt is rigid and made of optical glass material, whichachieves more than 90% of transmittance (higher than plastic LCD screenprotectors), thus making the LCD screen clear. liOnly 0.5mm thick with 4 layers of coatings and UVProtection. liOptical glass strengthened through special craftingprocess. liPrevent scratches, collisions and moderate impact to theLCD screen. liThe protector is reusable. Easy to Install:liNo trimming required, fit directly on your LCD screen. liJust clean your LCD screen first, peel off the white backof the protector to stick, Done! liEasy to install and bubbles free, unlike plastic protectorwhich always gives you bubbles between the protector and the screen. liNo adhesive backing at the LCD screen, only at the borderof the film for clearness. liCan be removed and reinstall, without leaving ugly residualon your LCD screen. How to remove:liUse a thin plastic business card or similar item (theplastic package of this protector could be used as the tool)to slide around the edge of the screen to remove it. liDo not pull or use fingernails to lift the four corners ofthe screen protector as it may break the glass protector, hurt yourfingers and/or damage the camera.

Get 81% OFF

Click here for more information about GGS Optical Glass LCD Screen Protector 3" for Digital Cameras